Magigoo HT

Magigoo HT is the professional 3D printing adhesive that works for higher temperatures. With Magigoo HT you apply a layer between the print bed and the printed part, which ensures that after the bed has cooled down the prints are relatively easy to remove and the print bed can be cleaned easily.

For filaments that need to be printed at a very high temperature such as PEEK, Ultem,... These offer higher mechanical and chemical stability compared to many other filaments.

High-temperature filaments can, due to these temperatures, more often stick harder to the print bed. Magigoo HT is formulated to prevent this when FDM printing your Peek filaments.

Apply to the desired area by pressing the tip onto the bed (activating the inner valve) and spreading if necessary.

Print according to the recommended settings

Allow to cool and remove; the print should pop off immediately

Clean, use a damp cloth to remove the residue

Use of this product with filaments other than PEEK filaments can cause excessive adhesion and damage your print bed.

For larger prints & filaments with high shrinkage, a brim of 20 mm is recommended.

In case of excessive adhesion, it is recommended to slowly work a small amount of water on the print bed under the printed part; this should make removing the part easier.

Technical data sheet & safety instructions & Magigoo Manual